Individual Map Light Test/Replacement

Individual Map Light Test/Replacement

1. Turn the individual map light switch OFF.

2. Carefully pry off the lens (A).

Individual Map Light: 8W x 2





3. Remove the two screws, then remove the individual map light (B).

4. Disconnect the connectors (C) from the individual map light.

5. Check for continuity between the terminals.

- There should be continuity between the terminal No. 3 and ground terminal with the switch in the ON position.
- There should be no continuity between the terminal No. 3 and ground terminal with the switch in the OFF position.

6. If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.

7. Install the light in the reverse order of removal.