KX Models

Control System DTCs

DTC Troubleshooting: P0133

DTC P0133 : A/F Sensor (Sensor 1) Malfunction/Slow Response

NOTE:
* Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information How To Troubleshoot The Fuel And Emissions Systems.
* If DTC P0139 is stored at the same time as DTC P0133, troubleshoot DTC P0139 first, then recheck for DTC P0133.

1. Problem verification:

Problem verification
-1. Turn the ignition switch to ON (II).

-2. Clear the DTC with the HDS.

-3. Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.

-4. Test-drive under these conditions:
* Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
* A/T in D, M/T in 3rd or 4th
* Engine speed between 1,500-3,300 rpm
* Drive the vehicle at 25 mph (40 km/h) or less for 5 minutes, then drive at a steady speed of 32 mph (52 km/h) or more

-5. Monitor the OBD STATUS for DTC P0133 with the HDS.

Does the HDS indicate FAILED?
-YES- Replace A/F sensor (Sensor 1) A/F Sensor Removal and Installation, then do the repair verification.
-NO- If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM. If the HDS indicates EXECUTING, keep driving until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-3 on this step and recheck.

Repair verification (OBD STATUS check):

-1. Turn the ignition switch to ON (II).

-2. Reset the ECM/PCM with the HDS How To Troubleshoot The Fuel And Emissions Systems.

-3. Do the ECM/PCM idle learn procedure. ECM/PCM Idle Learn Procedure

-4. Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.

-5. Test-drive under these conditions:
* Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
* A/T in D, M/T in 3rd or 4th
* Engine speed between 1,500-3,300 rpm
* Drive the vehicle at 25 mph (40 km/h) or less for 5 minutes, then drive at a steady speed of 32 mph (52 km/h) or more

-6. Monitor the OBD STATUS for DTC P0133 in the DTCs MENU with the HDS.

Does the HDS indicate PASSED, FAILED, EXECUTING, or OUT OF CONDITION?
-PASSED- Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated, go to the indicated DTC's troubleshooting.
-FAILED- Go to step 1 and recheck.
-EXECUTING- Keep the test condition until a result comes on.
-OUT OF CONDITION- Meet the test condition, and check the OBD STATUS again.