Accelerator Pedal Position Sensor: Testing and Inspection

Service Information

APP Sensor Signal Inspection

Inspection

1. HDS DLC - Connection





1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

2. APP Sensor Signal - Inspection

NOTE:
* This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures.
* Check for Pending or Confirmed DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
* Press the accelerator pedal several times to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module.

1. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

* If it is 0 %, the APP sensor is OK.
* If it is not 0 %, update the PCM if it does not have the latest software, or substitute a known-good PCM, then go to step 2.

2. With the accelerator pedal not pressed, check the APP SENSOR in the DATA LIST with the HDS.

* If it is 0 %, the APP sensor is OK.
* If it is not 0%, replace the accelerator pedal module, then recheck.