Side Impact Sensor (Second) Removal and Installation

Side Impact Sensor (Second) Removal and Installation

Removal

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Battery Terminal (SRS) - Disconnection





1. Make sure the ignition switch is in LOCK (0).

2. Disconnect and isolate the negative cable and battery sensor (A) from the battery (B).

NOTE: Always disconnect the negative side first.

3. Disconnect the positive cable (C) from the battery.

4. Wait at least 3 minutes before starting work.

2. Rear Seat Cushion





1. Remove the bolt (A) securing the rear seat cushion (B).





2. While pushing down the rear seat cushion (A), pull the seat hook handles (B) to release the hooks (C).

3. Remove the rear seat cushion.

3. Rear Seat-Back (Natural Gas Model)





1. Release the center seat belt (A) from the center belt guide (B).





2. Remove the bolts (A).





3. Remove the rear seat-back (A).

4. Side Impact Sensor (Second)





1. Disconnect the side impact sensor (second) connector on the floor wire harness.

2. Remove the TORX bolt using a TORX T30 bit, then remove the side impact sensor (second) (A).

Installation

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Side Impact Sensor (Second)





1. Install the side impact sensor (second) (A) with the new TORX bolt using a TORX T30 bit.

2. Connect the side impact sensor (second) connector on the floor wire harness.

2. Battery Terminal (SRS) - Reconnection





NOTE: If the battery performs abnormally, test the battery.

1. Clean the battery terminals.

2. Connect the positive cable (A) to the battery (B).

NOTE: Always connect the positive side first.

3. Connect the negative cable and battery sensor (C) to the battery.

4. Apply multipurpose grease to the terminals to prevent corrosion.

3. HDS DLC - Connection





1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

4. DTC - Clear

1. Clear the DTC(s) by following the screen prompts on the HDS.

2. Turn the ignition switch to LOCK (0), then wait for 10 seconds.

5. Confirm Proper SRS Operation

Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

6. Rear Seat-Back (Natural Gas Model)





1. Install the rear seat-back (A).





2. Install the bolts (A).





3. Install the center seat belt (A) to the center belt guide (B).

7. Rear Seat Cushion





1. Install the hooks (A) to the rear seat cushion clips (B).





2. Install the bolt (A) securing the rear seat cushion (B).