Multi-Information Display Unit Does Not Work

Audio System Symptom Troubleshooting - Multi-information display unit does not work

Multi-information display unit does not work

NOTE:
* Check the vehicle battery condition first Battery Test.
* Check the connectors for poor connections or loose terminals.

1. Problem verification:

Problem verification
-1. Turn the ignition switch to ON (II).

-2. Check if any MID information appears on the multi-information display unit.

Is there any information displayed?
-YES- Intermittent failure, the system is OK at this time.
-NO- The failure is duplicated, go to step 2.

2. Fuse check:

Fuse check
-1. Turn the ignition switch to LOCK (0).

-2. Check the following fuse.





Is the fuse OK?
-YES- Go to step 3.
-NO- Replace the fuse, and recheck. If the fuse blows again, check for a short in the No. A29 (10 A) fuse circuit.

3. Gauge control module DTC check:

Gauge control module DTC check
-1. Connect the HDS to the DLC.

-2. Turn the ignition switch to ON (II).

-3. Clear the DTCs with the HDS.

-4. Turn the ignition switch to LOCK (0) and then back to ON (II).

-5. Check for DTCs with the HDS.

Are any DTCs indicated?
-YES- Go to indicated DTC's troubleshooting.
-NO- Replace the multi-information display unit Multi-Information Display Unit Removal And Installation.