Power Mirror Actuator Test (2-Door)

Power Mirror Actuator Test

Removal

1. Front Door Panel (2-Door)





1. Remove the inner handle cap (A).





2. Remove the screw (A).





3. Remove the grip trim (A).





4. Remove the screws (A).





5. Remove the door panel (A).

Test

1. Power Mirror Actuator - Test (2-Door)









1. Disconnect the connector.

2. Check the actuator operation by connecting battery power and ground according to the table.

NOTE: To prevent damage to the actuator, apply battery voltage only momentarily.

3. If the mirror fails to work properly, the power mirror actuator is faulty; replace the power mirror.

Defogger Test

4. Check for continuity between power mirror connector terminals No. 1 and No. 3. There should be continuity. If the resistance is not as specified, check for an open or high resistance in the wire between the connector and mirror holder. If the wire is OK, replace the mirror holder.

Installation

1. Front Door Panel (2-Door)





1. Install the door panel (A).





2. Install the screws (A).





3. Install the grip trim (A).





4. Install the screw (A).





5. Install the inner handle cap (A).