Manufacturer Code Charts: 1303

Navigation System DTC Troubleshooting: 1303

DTC 1303:

GPS Receiver Error 2

NOTE:

- Check the vehicle battery condition first Battery Test.
- Before you troubleshoot, make sure to follow the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.
- This navigation DTC sets when there is an internal GPS receiver problem, or an open in GPS antenna lead.
- Check any official Honda service website for more service information about the navigation system.
- Check the connectors for poor connections or loose terminals.
- Aftermarket metallic window tint or electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Check for the hard error code.

Is DTC 1303 indicated?

YES -

The failure is duplicated, go to step 4.

NO -

Intermittent failure, the system is OK at this time.

4. Turn the ignition switch to LOCK (0).

5. Substitute a known-good GPS antenna Service and Repair.

6. Clear the hard error code.

7. Turn the ignition switch to LOCK (0), and then back to ON (II).

8. Check for the hard error code.

Is DTC 1303 indicated?

YES -

Replace the audio-navigation unit Audio-Navigation Unit Removal/Installation (With Navigation).

NO -

Replace the original GPS antenna Service and Repair.