A/T Countershaft Reverse Selector Hub Installation (A/T)

A/T Countershaft Reverse Selector Hub Installation

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Install 1st gear, 2nd gear, 3rd gear, the 33.2 x 40 x 26 mm collar, the 29 mm cotters, and the 33 x 45 x 7.8 mm collar on the countershaft, and secure them with the snap ring.

2. Install the needle bearings and the 4th-5th gear.

3. Slide the reverse selector hub (A) over the countershaft (B), then press it in place using the driver handle (40 mm I.D.) and a press.

NOTE: Some reverse selector hubs are not press-fitted, and can be installed without using the a press.