DTC Troubleshooting

DTC Troubleshooting: P0BEA (87)

DTC P0BEA:

V Phase Motor Current Sensor Circuit Malfunction

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.
- If the DTC cannot be cleared, do the troubleshooting for DTC U1204.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Monitor the OBD STATUS for DTC P0BEA in the DTCs MENU with the HDS.

Does the HDS indicate FAILED?

YES -

Go to step 4.

NO -

If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, go to step 1.

4. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0A61 and/or P0A62 indicated?

YES -

Do the troubleshooting for DTC P0A61 DTC Troubleshooting and/or DTC P0A62 DTC Troubleshooting.

NO -

Replace the phase motor current sensor Service and Repair, then go to step 5.

5. Turn the ignition switch to ON (II).

6. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0BEA indicated?

YES -

Go to step 1.

NO -

Go to step 7.

7. Monitor the OBD STATUS for DTC P0BEA in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES -

Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 6, go to the indicated DTC's troubleshooting.

NO -

If the HDS indicates FAILED, go to step 1. If the HDS indicates NOT COMPLETED, keep the ignition switch ON (II) until a result comes on.