Mirror Holder Replacement

Mirror Holder Replacement

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the power mirror or the related parts.
- When prying with a flat-tipped screwdriver, wrap it with protective tape to prevent damage.

1. Carefully push on the top edge of the mirror holder (A) by hand.





2. Put a shop towel in the opening between the bottom edge of the mirror holder and the mirror housing to prevent scratches, and detach the bottom hooks (B) with a flat-tip screwdriver.

3. Separate the mirror holder (A) from the actuator (B) by releasing the hooks (C). If equipped, disconnect the mirror defogger connectors (D).

NOTE: If you are only removing the mirror holder, go to step 5. If you are doing further disassembly of the mirror, proceed to step 4.






Mirror housing replacement

4. Remove the mirror housing (A).

1. Remove the screws (B, C).

2. Release the hooks (D), then remove the visor (E) and the mirror housing.





5. Before reinstalling the mirror holder to the inner holder (A) of the actuator, check the actuator rods (B) and the actuator boots (C).

NOTE: Make sure each actuator rod is inserted into the actuator securely, and each actuator boot is fully seated on the actuator.





6. Reconnect the mirror defogger connectors (D).

7. Reattach the hooks of the mirror holder to the actuator, then position the mirror holder on the actuator. Carefully push on the hook areas of the mirror holder until the mirror holder locks into place.

8. Check the actuator operation.