Programming and Relearning
ODS Unit Initialization
NOTE:
- After SRS unit, ODS unit or OPDS sensor is replaced, do this procedure to initialize the ODS unit.
- ODS unit initialization will initialize the OPDS sensor and the front passenger's weight sensor.
OPDS Sensor Initialization
After the front passenger's seat-back cover/pad, seat-back cushion, and/or ODS unit is replaced, do this procedure to initialize the OPDS sensor with the HDS.
NOTE:
- A new (uninitialized) ODS unit installed with a faulty OPDS sensor (DTCs 86-1x or 86-2x) can cause DTC 85-71 and DTC 85-78. If the SRS system has a hard DTC 86-1x or 86-2x, troubleshoot the DTCs completely before replacing the ODS unit.
- Before initializing the ODS unit, make sure the 12 volt battery is fully charged.
1. Clear the DTCs with the HDS.
2. Make sure the front passenger's seat is dry. Set the seat-back in a normal position, and make sure there is nothing on the seat.
3. Make sure the ignition switch is in LOCK (0).
4. Connect the HDS to the data link connector (DLC) (A).
5. Turn the ignition switch to ON (II).
6. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not, troubleshoot the DLC circuit DLC Circuit Troubleshooting (PGM-FI System).
7. From the HDS Main Menu, select SRS, then INITIALIZATION. In the INITIALIZATION Menu, select ODS Initialization. Follow the prompts until the OPDS sensor initialization has been completed.
8. Turn the ignition switch to LOCK (0), then wait for 10 seconds.
9. Disconnect the HDS from the DLC.
NOTE: If the ODS unit fails to initialize after several attempts, replace the seat-back cover/pad equipped with the OPDS sensor Service and Repair, retry. If the ODS unit continues to fail to initialize, replace the ODS unit Service and Repair.
Front Passenger's Weight Sensor Initialization
When you replace the SRS unit, the front passenger's weight sensor, the front passenger's seat assembly, or the ODS unit, initialize the front passenger's weight sensor with the HDS.
Before initializing the front passenger's weight sensor, observe these precautions:
- Make sure all components of the front passenger's seat are correctly installed.
- Make sure nothing is on the front passenger's seat.
- Make sure there is nothing in the front passenger's seat-back pocket.
- Keep the windows closed.
- Do all initialization procedures, except test-driving, in the service bay.
- Make sure the vehicle is on level ground.
- Dehumidify inside of the vehicle with A/C.
- Do not touch the front passenger's seat unless you are prompted to or when you have completed the initialization.
- Do not expose the front passenger's seat to sudden temperature changes.
- Always use a known weight as described in the procedure.
1. Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the initialization is completed.
2. Make sure the ignition switch is in LOCK (0).
3. Connect the HDS to the data link connector (DLC) (A).
4. Turn the ignition switch to ON (II).
5. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit DLC Circuit Troubleshooting (PGM-FI System).
6. Drive the vehicle, and accelerate to 22 mph (36 km/h), then stop on level ground.
7. From the Main Menu, select SRS, then SRS, then calibration, then select SWS INITIALIZATION, and follow the prompts until the calibration has been completed.
8. Turn the ignition switch to LOCK (0).
9. Disconnect the HDS from the DLC.