Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor Replacement

1. Remove the air cleaner Service and Repair.

2. Remove the heater hose clamps (A) and the IMA motor power cable clamps (B) from the bracket.






3. Disconnect the transmission range switch 8P connector (A) and the CVT output shaft (driven pulley) speed sensor 3P connector (B).





4. Remove the harness clamp (C) and the harness holder clamp (D) from the harness clamp bracket.

5. Remove the ground terminal bracket (A) from the transmission mount (B).






6. Remove the harness clamp bracket (A).






7. Remove the snap pin (B) and the control pin (C) from the control lever (D).

8. Remove the bolts securing the shift cable holder (E), then separate the shift cable (F) from the control lever.

9. Disconnect the vehicle speed sensor 3P connector (A), and remove the vehicle speed sensor (B).






10. Install a new O-ring (C) on a new vehicle speed sensor, then install the vehicle speed sensor in the transmission housing.

11. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

12. Apply molybdenum grease to the center of the shift cable end collar (A). Attach the shift cable end to the selector control lever (B). Insert the control pin (C) through the selector control lever hole (D), through the shift cable end hole, and into the selector control lever slotted hole (E) in the direction shown. Push the control pin until its flange (F) contacts the selector control lever surface.






13. Insert the snap pin (G) in the direction shown through the control pin hole and out the opening (H) of the selector control lever so that the hooked end (I) of the snap pin snaps into the countersunk hole (J) of the control pin.

14. Secure the shift cable holder on the transmission with the bolts.

15. Install the harness clamp bracket.

16. Install the ground terminal bracket (A).






17. Install the harness clamps (A) and the harness hold clamp (B).






18. Connect the transmission range switch 8P connector (C), and the CVT output shaft (driven pulley) speed sensor 3P connector (D).

19. Install the heater hose clamps (A) and IMA motor power cable clamp (B).






20. Install the air cleaner Service and Repair.