Transmission Position Sensor/Switch: Testing and Inspection

Transmission Range Switch Test

1. Remove the air cleaner Service and Repair.

2. Disconnect the transmission range switch 8P connector (A).






3. Check for continuity between terminals at the transmission range switch 8P connector (B). There should be continuity between the terminals in each switch position as shown in the following table.

Transmission Range Switch 8P Connector





4. The transmission range switch test is completed if the test results are OK. If there is no continuity between any terminals, go to step 5.

5. Remove the transmission range switch Service and Repair, and check the end of the selector control shaft (A).









6. If the measurement of the selector control shaft end is within the standard, replace the transmission range switch Service and Repair. If the measurement is out of the standard, repair the selector control shaft end, then install the transmission range switch Service and Repair, and recheck the transmission range switch continuity.