Removal and Replacement
Lock Plate and Rod Replacement - Lift Gate
Removal Procedure
1. Remove the liftgate trim panel. Refer to Trim Panel Replacement - Lift Gate (Trim Panel Replacement - Lift Gate) .
2. Disconnect the lock actuator electrical connection.
3. Disconnect the latch control cables by releasing the retainers (2) and removing the cable ends from the cups. Note the routing.
4. Remove the fasteners (1) retaining the control assembly to the liftgate.
5. Remove the lock plate assembly from the liftgate.
Installation Procedures
Notice: Refer to Fastener Notice Service Precautions in Cautions and Notices.
1. Position the lock plate assembly in place on the liftgate, and install the fasteners (1) retaining the control assembly to the liftgate.
Tighten the fasteners to 9 Nm (7 lb ft).
2. Connect the latch control cables (2) to the control assembly by placing the cable ends in their cups and securing the retainers. Note the proper routing.
3. Connect the lock actuator electrical connector.
4. Inspect for proper operation.
5. Install the liftgate trim panel. Refer to Trim Panel Replacement - Lift Gate (Trim Panel Replacement - Lift Gate) .