Instrument Cluster / Carrier: Service and Repair
INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster.
1. Remove the I/P cluster trim plate from the instrument panel.
2. Remove the screws from the I/P cluster to instrument panel.
3. Gently remove the I/P cluster from the instrument panel.
4. Disconnect the electrical connections from the cluster.
INSTALLATION PROCEDURE
1. Connect the electrical connections to the cluster.
2. Position the I/P cluster to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the screws to the instrument panel cluster.
Tighten
Tighten the screws to 2 N.m (15 lb in).
4. Install the instrument cluster trim plate.
When installing a new I/P cluster, it must be synchronized to the supplemental inflatable restraint (SIR) module in order to synchronize the new cluster. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster.