Marker Lamp Replacement - Front Side
MARKER LAMP REPLACEMENT - FRONT SIDEREMOVAL PROCEDURE
1. Open the hood.
2. Disconnect the electrical connector.
3. Remove the fastener from the hood.
4. Remove the screws from the lamp.
5. Remove the lamp, with the attached harness, from the vehicle.
INSTALLATION PROCEDURE
1. Install the lamp, with the attached harness, to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the screws to the lamp.
Tighten
Tighten the nuts to 3 N.m (26 lb in).
3. Install the fastener to the hood.
4. Connect the electrical connector.
5. Close the hood.