I/Panel Electrical Center or Junction Block Replacement - Right
INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT - RIGHTREMOVAL PROCEDURE
1. Remove the right side end panel.
2. Push in the tabs in order to remove the fuse block.
3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
4. Loosen the bolt.
5. Insert a screw driver between the wire harness block and fuse block in order to separate.
6. Separate the fuse block from the I/P harness block.
7. Remove the IP wiring harness block from the vehicle.
INSTALLATION PROCEDURE
1. Install the fuse block to the I/P wire harness block.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the retaining bolt.
Tighten
Tighten the bolt to 6 N.m (53 lb in)
3. Install the fuse block to the I/P till it clicks in place.
4. Connect the wiring connectors to the fuse block.
5. Install the right side end panel.