Crankshaft, Engine

ENGINE MECHANICAL SPECIFICATIONS
Crankshaft End Play 0.04-0.2 mm (0.0015-0.0078 in)
Crankshaft Main Bearing Clearance - Production 0.02-0.052 mm (0.0008-0.0021 in)
Crankshaft Main Bearing Clearance - Service 0.02-0.065 mm (0.0008-0.0025 in)
Crankshaft Main Journal Diameter - Production 64.993-65.007 mm (2.558-2.559 in)
Crankshaft Main Journal Diameter - Service 64.993 mm (2.558 in)
Crankshaft Main Journal Out-of-Round - Production 0.003 mm (0.000118 in)
Crankshaft Main Journal Out-of-Round - Service 0.008 mm (0.0003 in)
Crankshaft Main Journal Taper - Production 0.01 mm (0.0004 in)
Crankshaft Main Journal Taper - Service 0.02 mm (0.00078 in)
Crankshaft Rear Flange Runout 0.05 mm (0.002 in)
Crankshaft Reluctor Ring Runout - Measured 1.0 mm (0.04 in) Below Tooth Diameter 0.7 mm (0.028 in)
Crankshaft Thrust Surface - Production 26.14-26.22 mm (1.029-1.0315 in)
Crankshaft Thrust Surface - Service 26.22 mm (1.0315 in)
Crankshaft Thrust Surface Runout 0.025 mm (0.001 in)
Crankshaft Main Bearing Bore Diameter 69.871 - 69.889 mm (2.75 - 2.751 in)
Crankshaft Main Bearing Bore Out of Round 0.006 mm (0.0002 in)

FASTENER TIGHTENING SPECIFICATIONS
Crankshaft Balancer Bolt Installation Pass - to Ensure the Balancer is Completely Installed 330 N.m (240 lb ft)
Crankshaft Balancer Bolt - First Pass - Install a NEW Bolt After the Installation Pass and Tighten as Described in the First and Final Passes 50 N.m (37 lb ft)
Crankshaft Balancer Bolt - Final Pass 140 degrees
Crankshaft Bearing Cap Bolts - Inner Bolts - First Pass in Sequence 20 N.m (15 lb ft)
Crankshaft Bearing Cap Bolts - Inner Bolts - Final Pass in Sequence 80 degrees
Crankshaft Bearing Cap Bolts - Outer Bolts - First Pass in Sequence 20 N.m (15 lb ft)
Crankshaft Bearing Cap Bolts - Outer Bolts - Final Pass in Sequence 51 degrees
Crankshaft Bearing Cap Side Bolts 25 N.m (18 lb ft)
Crankshaft Oil Deflector Nuts 25 N.m (18 lb ft)
Crankshaft Position Sensor Bolt 25 N.m (18 lb ft)