Lubricant Level Inspection - Front Drive Axle

LUBRICANT LEVEL INSPECTION - FRONT DRIVE AXLE




1. Raise the vehicle. Refer to Vehicle Lifting.
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Remove the engine protection shield (if equipped).
5. Clean the area around the front axle fill plug (1).
6. Remove the front axle fill plug (1).
7. Inspect the oil level.

Specification
The oil level should be between 0-10 mm (0-0.375 in) below the fill plug opening.

8. If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.

NOTE: Refer to Fastener Notice in Service Precautions.

9. Install the fill plug.

Tighten
Tighten the plug to 33 N-m (24 lb ft).

10. Install the engine protection shield.
11. Lower the vehicle.