Instrument Cluster / Carrier: Service and Repair

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster.




1. Remove the I/P cluster trim plate from the instrument panel.




2. Remove the screws from the I/P cluster to instrument panel.
3. Remove the I/P cluster from the instrument panel.




4. Disconnect the electrical connections from the cluster.

INSTALLATION PROCEDURE




1. Connect the electrical connections to the cluster.




2. Position the I/P cluster to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screws to the instrument panel cluster.

Tighten
Tighten the screws to 2 N.m (18 lb in).




4. Install the instrument cluster trim plate.
When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Service Programming System (SPS) in Vehicle Control Systems.