Marker Lamp Replacement - Rear Side

MARKER LAMP REPLACEMENT - REAR SIDE

REMOVAL PROCEDURE




1. Remove the interior trim panel.
2. Remove the wiring harness fastener from the body.
3. Disconnect the electrical connector.
4. Remove the screws from the lamp.
5. Remove the lamp, with the attached harness, from the vehicle.

INSTALLATION PROCEDURE




1. Install the lamp, with the attached harness, to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws to the lamp.

Tighten
Tighten the screws to 3 N.m (26 lb in).

3. Connect the electrical connector.
4. Install the wiring harness fastener to the body.
5. Install the interior trim panel.