Differential Carrier Assembly Bushing Replacement (Differential Carrier)

DIFFERENTIAL CARRIER ASSEMBLY BUSHING REPLACEMENT (DIFFERENTIAL CARRIER)

TOOLS REQUIRED
J 45755 Front Axle Bushing Remover/Installer

REMOVAL PROCEDURE




1. Remove the differential carrier assembly. It is not necessary to drain the differential carrier assembly. Seal the vent tube opening with a piece of tape to prevent the axle lubricant from leaking from the differential carrier assembly.
2. Install the J 45755-3 (2), J 45755-4 (3), and the forcing screw, bearing and the washers (1) over the differential carrier assembly bushing as shown.
3. Remove the differential carrier assembly bushing using the J 45755.

INSTALLATION PROCEDURE




1. Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
2. Install the J 45755-2 (2), J 45755-1(3), and the forcing screw, bearing and washers (1) over the differential carrier assembly bushing as shown.
3. Press the bushing into the differential carrier assembly bushing bore using the J 45755.
4. Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the piece of tape in order to connect the vent hose.