Operation CHARM: Car repair manuals for everyone.

Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing)

DIFFERENTIAL CARRIER ASSEMBLY BUSHING REPLACEMENT (INNER AXLE SHAFT HOUSING)

TOOLS REQUIRED
J 45755 Front Axle Bushing Remover/Installer

REMOVAL PROCEDURE




1. Remove the inner shaft housing.
2. Install the inner shaft housing into a vise.
3. Install the J 45755-2 (2), J 45755-1(1), and the forcing screw, bearing and washers (3) over the inner shaft housing bushing as shown.
4. Remove the inner shaft housing bushing using the J 45755.

INSTALLATION PROCEDURE




1. Install the inner shaft bushing into the inner shaft housing bushing bore. Ensure that the inner shaft bushing is positioned so that the bushing is being driven in from the front of the inner shaft housing towards the rear of the inner shaft housing.
2. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner shaft housing bushing as shown.
3. Press the bushing into the inner shaft housing bore using the J 45755.
4. Remove the inner shaft housing from the vise.
5. Install the inner shaft housing.