Lubricant Replacement - Rear Drive Axle
LUBRICANT REPLACEMENT - REAR DRIVE AXLEREMOVAL PROCEDURE
1. Raise the vehicle. Refer to vehicle Lifting.
2. Remove the rear axle fill plug.
3. Remove the rear axle drain plug.
4. Drain the lubricant into a suitable container.
5. Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
6. Clean the drain plug.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the rear axle drain plug.
Tighten
Tighten the rear axle drain plug to 33 N.m (24 lb ft).
2. Fill the rear axle. Use the proper fluid. Refer to Capacities - Approximate Fluid and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
3. Install the rear axle fill plug.
Tighten
Tighten the rear axle drain plug to 33 N.m (24 lb ft).
4. Lower the vehicle.