Transfer Case Input Shaft Seal Replacement
TRANSFER CASE INPUT SHAFT SEAL REPLACEMENTTOOLS REQUIRED
J 42738 Seal Installer
J 36825 Output Shaft Oil Seal Remover
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case from the adapter.
3. Using the J 36825 remove the input shaft seal from the transfer case by threading the self tapping screw (2) into the seal.
INSTALLATION PROCEDURE
IMPORTANT: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician). The input shaft seal should be even with the surface of the transfer case after installation.
1. Position the seal on the input shaft.
2. Using the J 42738, install the input shaft seal in the transfer case.
3. Install the transfer case to the adapter.
4. Lower the vehicle. Refer to Vehicle Lifting.