Transfer Case Output Shaft Seal Replacement - Rear
TRANSFER CASE OUTPUT SHAFT SEAL REPLACEMENT - REARTOOLS REQUIRED
J 45756 Rear Output Shaft Seal Installer
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.
INSTALLATION PROCEDURE
1. Using J 45756, install a NEW front output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Lower the vehicle.