Seat Back Cover and Pad Replacement - Front

Seat Back Cover and Pad Replacement - Front

Removal Procedure

1. Remove the head restraint. Refer toHead Restraint Replacement (Head Restraint Replacement) .
2. Remove the seat trim panel. Refer toTrim Panel Replacement - Front Seat (Front Seat Trim Panel Replacement) .




3. Remove the outboard seat belt anchor nut. Pull the seat belt through the seat cushion.
4. Disengage the J-strip retainer on the bottom of the seat back cover.
5. Disconnect the heater seat element connector, if equipped.




6. Using a side motion, carefully lift the seat back cover partially off the foam pad in order to access the arm rest clip.
7. Remove the armrest, if equipped. Refer toArmrest Replacement - Front Seat (Armrest Replacement - Front Seat) .
8. Using a flat bladed tool lift the seat cover over the air bag cover.
9. Remove the seat cover to the top of the seat.




10. Disengage the panel fasteners in order to remove the rear cardboard panel.
11. Unclip the head restraint retainers. Refer toHead Restraint Retainer Replacement - Front Seat (Seats) .
12. Remove the bolts which retain the seat belt tower cover.




13. Remove the seat belt tower cover.
14. Pull the seat belt and the seat belt bezel through the opening in the seat cover.
15. Lift the remainder of the seat back cover off the foam pad.
16. Carefully remove the foam pad from the frame.



Installation Procedure

1. Attach the foam pad to the frame.




2. Install the seat belt tower.

Notice: Refer toFastener Notice in Cautions and Notices.

3. Install the bolts which retain the seat belt tower cover.

Tighten the bolts to 1.9 Nm (17 lb in).





4. Install the rear cardboard panel. Engage the panel fasteners.
5. Install the seat back cover partially onto the top of the frame.
6. Feed the seat belt and the seat belt bezel through the tower opening.
7. Install the arm rest clip.




8. Pull the rest of the cover down using a side-to-side motion.
9. Install the armrests, if equipped. Refer toArmrest Replacement - Front Seat (Armrest Replacement - Front Seat) .
10. Install the head restraint retainers. Refer toHead Restraint Retainer Replacement - Front Seat (Seats) .
11. Fit the seat cover around the air bag cover.




12. Pull the seat belt down through the seat cushion and install the outboard seat belt anchor nut.

Tighten the nut to 53 Nm (39 lb ft).

13. Install the seat trim panel. Refer toTrim Panel Replacement - Front Seat (Front Seat Trim Panel Replacement) .
14. Install the head restraints. Refer toHead Restraint Replacement (Head Restraint Replacement) .
15. Push on the seat cover. Ensure that the cover is retained by the velcro in the seat cushion.
16. Connect the J-strip at the bottom of the seat.