Marker Lamp Replacement - Front Side

MARKER LAMP REPLACEMENT - FRONT SIDE

REMOVAL PROCEDURE
1. Open the hood.




2. Disconnect the electrical connector (5).
3. Remove the screws from the lamp housing.
4. Remove the lamp, with the attached harness (1), from the hood.

INSTALLATION PROCEDURE
1. Install the lamp, with the attached harness, to the hood.




2. Install the screws to the lamp housing.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (26 lb in).

3. Connect the electrical connector and secure the harness.
4. Close the hood.