Marker Lamp Replacement - Rear Side (SUT Right)

MARKER LAMP REPLACEMENT - REAR SIDE (SUT RIGHT)

REMOVAL PROCEDURE




1. Remove the RH rear compartment side trim panel (1).
2. Remove the screws retaining the exterior lamp lens to the outer body panel.




3. Disconnect the electrical connector (1) from the main body harness (5).
4. Remove the RH rear side marker lamp with harness (4) from the rear body panel.

INSTALLATION PROCEDURE




1. Position the harness into the RH rear body opening (3).
2. Connect the electrical connector (1) to the main body harness (5).
3. Ensure the electrical connection is secure to the inside body panel (2).
4. Position the lamp to the outer body panel.
5. Install the screws with foam washers.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (26 lb in).




6. Install the RH rear compartment side trim panel (1).