Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure

Important: The ignition switch must be in the OFF position when removing the instrument panel (I/P) cluster.




1. Remove the I/P cluster trim plate from the instrument panel.
2. Remove the screws from the I/P cluster to instrument panel.




3. Remove the I/P cluster from the instrument panel.




4. Disconnect the I/P cluster electrical connections.

Installation Procedure




1. Connect the electrical connections to the cluster.
2. Position the I/P cluster to the instrument panel.






Notice: Refer to Fastener Notice.

3. Install the screws to the instrument panel cluster.

Tighten the screws to 2 N.m (18 lb in).




4. Install the instrument cluster trim plate.
When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Instrument Cluster Programming and Setup. Programming and Relearning