Clutch Control Replacement

REMOVAL









1. Drain the clutch fluid through the bleed plug.
2. Remove the clevis pin, washer and cotter pin.
3. Disconnect the clutch line (master cylinder side).
4. Remove the master cylinder mounting bolt.





5. Remove the clutch line clips.
6. Hold the nut on the clutch hose and loosen the flare nut on the clutch line.





7. Remove the clip from the clutch hose and remove the hose from the bracket.
8. Remove the clutch line.





9. Disconnect the clutch line (release cylinder side).

INSPECTION
1. Check the clutch hose or lines for cracks or restrictions.

INSTALLATION





1. Connect the clutch line (release cylinder side).





2. Temporarily tighten the flare nut by hand. then tighten it to the specified torque. being careful that the clutch hose does not become twisted.





3. Install the clutch line and clips.





4. Install the master cylinder.





5. Apply the specified grease to the clevis pin and washer.

Specified grease : Wheel bearing grease SAE J310, NLGI No.2

6. nstall the push rod to the clutch pedal.
7. Refill the clutch master cylinder with fluid.
8. Bleed the system.