A/C Signal: Testing and Inspection

1. Start and warm the engine to operating temperature. Turn the blower and A/C to the ON position.
2. Using a volt meter, check the voltage between engine control module harness terminal 6 and ground.

Voltage: Should equal system voltage.

NOTE: If voltage does not exist and the harness tests O.K. check the A/C system for faults.

3. Turn the key to the OFF position and disconnect the negative battery terminal and engine control module connector.
4. Using an ohm meter, check for continuity between engine control module harness terminal 6 and harness terminal 2 of the A/C dual pressure switch.

Continuity: Should exist.

5. Using an ohmmeter check for continuity between Engine Control Module harness terminal 6 and ground.

Continuity: Should not exist.

NOTE: If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, confirm that the repair has corrected the problem. If the trouble returns, it is possible that there is an intermittent failure of the component or the engine control module. Check for looseness at all harness junctions and test for an intermittent failure.