Refrigerant Pressure Sensor / Switch: Description and Operation

DUAL PRESSURE SWITCH




The dual pressure switch is a combination of the low pressure switch (for checking the quantity of refrigerant) and the high pressure switch (for prevention of overheating). It is installed in the receiver, and, when the pressure becomes approximately 200 kPa (29 psi) or lower, the compressor stops, thus preventing the compressor from being damaged by heat.




When the pressure reaches 3,241 kPa (470 psi) or higher, the compressor stops, thus preventing overheating. There is generally no necessity for inspection; if, however, an unusual condition, such as non-operation of the compressor is encountered, check by following the procedures below.