Manual Control Cable

Manual Control Cable

Manual linkage adjustment can be verified by checking operation of the inhibitor switch.
- Apply the parking brake and service brakes.
- Place the selector lever in the "R" range.
- Set ignition key to the "ST." position.
- Slowly move the selector lever upward until it clicks as it fits into the notch of the "P" range. If the starter motor operates when the lever makes a click, the "p" position is correct.
- Then, slowly move the selector lever to the "N" range by the same procedure. If the starter motor operates when the selector lever fits into "N", the "N" position is correct.
- Also, check that the vehicle doesn't begin to move and the lever doesn't stop between P-R-N-D.
- The manual-control cable is properly adjusted if, as described above, the starter motor starts at both the "P" range and the "N" range.