Tightening Torque Specifications

TIGHTENING TORQUE SPECIFICATIONS

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

Camshaft Bearing Cap Tightening Sequence





Cylinder Head Tightening Sequence


Main Bearing Cap Tightening Sequence
Install bearing caps and tighten cap bolts to the specified torque in the sequence of the center, No.2, No.4 front and rear caps. Cap bolts should be tightened evenly in 2 to 3 stages before they are tightened to the specified torque. The caps should be installed with the arrow mark directed toward the crank pulley side of engine. Cap numbers must be corrected.





Drive Plate/Flywheel