Air Bag: Testing and Inspection

If any improper parts are found during the following inspection, replace the airbag module with a new one.
Dispose the old one according to the specified procedure.

CAUTION: Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

1. Check pad cover for dents, cracks or deformities.









2. Check the airbag module for denting, cracking or deformation.
3. Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4. Check airbag inflator case for dents, cracks or deformities.

CAUTION:
Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.






Never attempt to disassemble and repair the airbag modules (DAB,PAB), clock spring and wiring in order to reuse them.
If any component of SRS has been dropped, or if there are cracks, dents or other defects in the case, bracket or connector, replace them with new ones.