Engine and Transaxle Installation

INSTALLATION
1. After checking the connections of the harnesses, pipes, hoses, etc and making sure that none of them get caught, damaged, etc., install the engine and transaxle assembly.





2. Install the mounting stoppers with the arrows on them pointing in the direction as shown.





3. When the engine and transaxle assembly is installed, temporarily tighten the front roll stopper.





4. The front and rear center member rubber bushings and collars are different.
5. After the weight of the engine and transaxle assembly has been applied to each insulator, tighten to the specified torque.
6. Reassemble all of the components removed during disassembly. Be especially careful to properly secure all components, including fuel, electrical and fluid pipe connections.
7. Refill the coolant and check for leak.
8. Refill the transaxle fluid, test its operation, and check for leaks.
9. Check the operation of the transaxle control cable and accelerator cable. Adjust as necessary.
10. Check for proper operation of each of the various gauges.