With Manufacturer's Scan Tool

USING HI-SCAN








1. Turn OFF the ignition switch.
2. Connect the HI-SCAN to the data link connector.
3. Turn ON ignition switch.
4. Use the HI-SCAN to check the diagnostic trouble code.
5. Repair the faulty part from the diagnosis chart.
6. Erase the diagnostic trouble code.
7. Disconnect the HI-SCAN.

NOTE:
- As many as ten diagnostic trouble codes, in the sequence of occurrence, can be stored in the Random Access Memory (RAM) incorporated within the control module.
- The same diagnostic trouble code can be stored just one time.
- If the number of stored diagnostic trouble codes or diagnostic trouble patterns exceeds ten, already stored diagnostic trouble codes will be erased, in sequence beginning with the oldest.
- Do not disconnect the battery until all diagnostic trouble codes or diagnostic trouble patterns have been read out, because all stored diagnostic trouble codes or diagnostic trouble patterns will be canceled when the battery is disconnected.
- If the auto transaxle fluid temperature reaches over 50° and 200 times from the initial memory, the fault code will be erased.
- If the fail-safe system is activated and the transaxle is locked in third gear, the diagnostic trouble code in the Fail-Safe Code Description will be stored in the RAM.
- The cancelation will occur if, with the transaxle locked in 3rd gear, the ignition key is turned to the OFF position, but the diagnostic trouble code is stored in the RAM.