Component Tests and General Diagnostics

HEATED OXYGEN SENSOR (HO2S)

The heated oxygen sensor senses the oxygen concentration in exhaust gas and converts it into a voltage which is sent to the PCM. The oxygen sensor outputs about 0 V when the air fuel ratio is richer than the theoretical ratio, and outputs about 5 V when the ratio is more lean (higher oxygen concentration in exhaust gas.). The PCM controls the fuel injection ratio based on this signal so that the air fuel ratio is maintained at the stoichiometric ratio. The oxygen sensor has a heating element which ensures sensor performance during all driving conditions.

Circuit Diagram:

TROUBLESHOOTING HINTS
1. If the HO2S is defective, abnormally high emissions may occur.
2. If the HO2S check results were normal, but the sensor output voltage is out of specification, check for the following items (related to air fuel ratio control system):
- Defective injector
- Air leaks in the intake manifold.
- Defective air flow sensor, intake air temperature sensor, and engine coolant temperature sensor.

Using GST:

INSPECTION (USING VOLTMETER)

Standard Value:

1. Disconnect the oxygen sensor connector, and measure the resistance between terminal 3 and terminal 4.

NOTE: Before checking, warm up the engine until the engine coolant temperature reaches 80 to 95 °C (176 to 205 °F).

2. Apply battery voltage directly between terminal 3 and terminal 4.

NOTE: Be careful when applying the voltage. Damage will result if the terminals are incorrect or are short circuited.

3. Connect a digital-type voltmeter between terminal 1 and terminal 2.




4. While repeatedly racing the engine, measure the oxygen sensor output voltage.




5. If there is a problem, there may be an oxygen sensor malfunction.

Tightening torque
Heated oxygen sensor: 40 - 50 Nm (400 - 500 kg.cm, 29 - 36 lb.ft)

Harness Inspection Procedure: