Knock Sensor: Testing and Inspection

KNOCK SENSOR





The knock sensor is attached to the cylinder block and senses engine knocking conditions. A knocking vibration from the cylinder block is applied as pressure to the piezoelectric element. This vibrational pressure is then converted into a voltage signal which is delivered as output. If engine knocking occurs, ignition timing is retarded to suppress it.

Circuit Diagram:

Harness Inspection Procedure:

SENSOR INSPECTION




1. Disconnect the knock sensor connector.
2. Measure resistance between the terminal 2 and 3.

Standard value : about 5MOhm [at 20 °C (68 °F)]

3. If the resistance is continual, replace the knock sensor.

Knock sensor : 16 - 28 Nm (160 - 250 kg.cm, 11.8 - 18.4 lb.ft)

4. Measure the capacitance between the terminal 2 and 3.

Standard value : 800 - 1600 pF