Programming and Relearning

PASSWORD SETTING
Password can be used to register the master keys when you lost the ID key by using a tester (such as Hi-scan).

1. INITIAL PASSWORD
The initial password for ICM has been set by the manufacturer as 2345.

Key can be registered and corrected by using the initial password until a new password is registered.

2. PASSWORD REGISTRATION AND CHANGE
Using a tester (Hi-scan), the initial password (preset as 2345 all) can be replaced by a new password nominated by the owner.

4 numbers among 0-9 can be registered as password. Once the password has been changed from 2345, the ICM is ready to record the ID code.

KEYS REGISTRATION AND CORRECTION

Initial Registration Method:

INITIAL REGISTRATION METHOD

REGISTRATION CORRECTION FOR MASTER KEYS
In cases when the master key is lost or where a new set of master keys need to be produced, it can be achieved using two methods.




1. Using ID key

2. Using password




When the customers lost the ID key, new master keys can be registered by using Hi-scan only. ID key can not be corrected and reproduced.

NOTE: Once the password is mis-registered, it is impossible to register new password during 10 seconds regardless of ignition ON/OFF.
When the new master keys have been registered, the codes for existing master keys are all cleared. The password should consist of 4 numbers among ten (0-9) numbers.