Replacement of Sub-Components
REPLACEMENTBALL JOINT AND DUST COVER
1. Using a flat-tipped screwdriver, remove the dust cover from the lower arm ball joint.
2. Remove the snap ring.
3. Using a plastic hammer, tap the ball joint out of the lower arm.
4. Using special tool (09545-11000), press-fit the ball joint into the lower arm assembly.
5. Install the snap ring.
6. Using the special tool (09545-21100), install the dust cover.
LOWER ARM BUSHING (G)
1. Install the special tools (09545-02000, 09216-21100 and 09216-21200) on the lower arm.
2. Press out the bushing.
3. Apply soap solution to the following parts.
^ Outer surface of the bushing
^ Inner surface of the lower arm bushing mounting part.
4. Install the new bushing on the lower arm by using special tools (09216-21100, 09624-34000).
NOTE: Press-in the lower arm bushing (G) in the same direction as shown in illustration.