Operation CHARM: Car repair manuals for everyone.

Rear Wiper Motor

REAR WIPER MOTOR

REMOVAL
1. Remove the tail gate trim.
2. Detach the wiper cap (A), and then remove the rear wiper arm after removing a nut (B).

Tightening torque Nut (B) : 10 - 13 Nm (1.0 - 1.3 kgf.m, 7.2 - 9.4 lbf.ft)






3. Detach the wiper motor cover, and then remove the rear wiper cap & pad (B) after removing a nut (A).

NOTE: When installing the rear wiper cap & pad, in order for the arrow mark toward an upper direction.

Tightening torque Nut (A) : 10 - 13 Nm (1.0 - 1.3 kgf.m, 7.2 - 9.4 lbf.ft)






4. Disconnect the rear wiper motor connector (B) then remove the rear wiper motor (A) after removing 2 bolts.

Tightening torque Nut : 7 - 11 Nm (0.7 - 1.1 kgf.m, 5.1 - 8.0 lbf.ft)

5. Installation is the reverse of removal.

INSTALLATION
1. Install the rear wiper arm and blade to the specified position.






2. Set the rear washer nozzle on the specified spray Position.