Repair Procedures

Removal

NOTE:
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.

1. Remove the console.
2. Loosen the adjusting nut (A) and the parking brake cables.




3. Disconnect the connector (A) of parking brake switch.




4. Remove the parking brake lever assembly (A) with loosening the bolts (B).




5. Remove the wheel and tire.
6. Remove the brake drum(A).




7. Remove the rear hub unit bearing(A).




8. Remove the shoe hold down pin (A) and the spring (B) by pushing the retainer spring and turning the pin.




9. Remove the adjuster assembly (A) and the return spring (B).




10. Remove the parking brake cable (B) from the brake shoe (A).




11. Remove the strut (A) and the strut spring (B).




12. Remove the brake shoe.

Installation

1. Install the brake shoe(A) to the backing plate(B).
2. Install the shoe hold down pin(C) and the spring(D) by pushing the retainer spring (D) and turning the pins.
3. After installing the strut(C) and upper return spring(D), install the adjuster assembly(B) and the lower return spring(C).




4. Apply a coating of the specified grease to each sliding parts of parking brake as shown.

Specified grease :
Multi purpose grease SAE J310, NLGI No.2





5. Install the rear brake disc/drum and rear brake caliper.
6. After installing the cable adjuster, adjust the parking brake lever stroke.