Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to data link connector (DLC)
2. Ignition "ON" & Engine "OFF".
3. Monitor the "TRANSAXLE RANGE SWITCH" parameter on the scantool
4. Shift selector lever from "P" range to other range.








fig 1)"P" Range
fig 2)"R" Range
fig 3)"N" Range
fig 4)"D" Range
5. Does "TRANSAXLE RANGE SWITCH" follow the referance data ?






NOTE:
** Most of fault that happen about inhibitor switch, result from faulty shift cable adjustment or incorrect location of manual control lever and inhibitor switch. So, when DTC which related Inhibitor switch or engine start defectiveness at "P" range happen, After check the shift cable adjustment or location of manual control lever and inhibitor switch, repair or replace as necessary.