Scantool Diagnostics

Monitor Scantool Data

1. Check status
(1) IG "ON" & Engine "OFF"
(2) Monitor the "ECM Status" Parameter on the Scantool.

Specification : 'LEARNT'





fig 1) This data show that 3 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt
(3) Has the ECM been learnt ?






NOTE:
- If the EMS is only replaced using an existing key and SMARTRA3, after replacing the "virgin" or "neutral" EMS, reteaching is possible by key Learning mode of scanner.
- When the same PIN used in existing vehicle is only inputted, the SMARTRA3 Learning and key Learnings are possible.