Component Inspection

Component Inspection

Check tilt switch
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "TILT UP (DOWN) SWITCH" Parameter on the Scantool. While operating tilt switch.

Specification : Refer the specifications in fig. 1), fig. 2)





fig. 1) When UP switch is pressed
fig. 2) When DOWN switch is pressed
fig. 1), fig. 2) Current Data of tilt switch.
4. Is the measured current data within specifications ?





Check tilt motor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select "ACTUATION TEST" mode on scantool and press [F1] to start




fig. 3) Actuation Test of tilt motor
4. Dose tilt motor work properly ?





Check tilt sensor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "TILT SENSOR" Parameter on the Scantool. While operating tilt switch.

Specification : Refer the specifications in fig. 5)





fig. 4) Current Data of tilt position
fig. 5) Current data of tilt sensor as a function of vertical position of steering wheel.
4. Is the measured voltage within specifications in fig 5) ?