Component Inspection

Body Control

Integrated Memory System - B1954 Slide Motor Or Sensor Error - Component Inspection

Component Inspection

Check powerseat slide switch
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "SLIDE FORWARD (BACKWARD) SW " Parameter on the Scantool. While operating powerseat slide switch.

Specification : Refer the specifications in Fig.1), Fig.2)




Fig.1) When FWD switch is pressed
Fig.2) When Back switch is pressed
Fig.1), Fig.2) Current Data of powerseat slide switch.
4. Is the measured current data within specifications?





Check powerseat slide motor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select "ACTUATION TEST" mode on scantool and press [F1] to start




Fig.3) Actuation Test of powerseat slide motor
4. Dose powerseat slide motor work properly?





Check powerseat slide sensor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "SLIDE POSITION" Parameter on the Scantool. While operating powerseat slide switch.

Specification : Refer the specifications in Fig.5)




Fig.4) Current Data of powerseat slide position
Fig.5) Current data of powerseat slide sensor as a function of horizontal position of powerseat.
4. Is the measured voltage within specifications in Fig.5)?