Component Inspection

Body Control

Integrated Memory System - B1960 Tele Position Sensor Error - Component Inspection

Component Inspection

Check Telescope switch
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "TELESCO. FORWARD (BACKWARD) SW " Parameter on the Scantool. While operating Telescope switch.

Specification : Refer the specifications in Fig.1), Fig.2)




Fig.1) When FWD switch is pressed
Fig.2) When Back switch is pressed
Fig.1), Fig.2) Current Data of Telescope switch.
4. Is the measured current data within specifications?





Check Telescope motor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select "ACTUATION TEST" mode on scantool and press [F1] to start




Fig3) Actuation Test of Telescope motor
4. Dose Telescope motor work properly?





Check Telescope sensor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "TELESCOPE SENSOR" Parameter on the Scantool. While operating telescope switch.

Specification : Refer the specifications in Fig.5)




Fig.4) Current Data of Telescope position
Fig.5) Current data of Telescope sensor as a function of length of steering column4) Current Data of Telescope position
4. Is the measured voltage within specifications in Fig.5)?