Component Inspection

Body Control

Driver Door Module - B1910 Outside Mirror Left Horizontal Motor or Sensor Error Component Inspection

Component Inspection

Check left outside mirror switch
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Monitor the "DR. MIRROR RIGHT (LEFT) SW " Parameter on the Scantool. While operating left outside mirror switch.

Specification : Refer the specifications in Fig.1), Fig.2)





Fig.1) When right switch is pressed
Fig.2) When left switch is pressed
Fig.1), Fig.2) Current Data of left outside mirror switch.
4. Is the measured current data within specifications?





Check left outside mirror motor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Select 'ACTUATION TEST' mode on scantool and press [F1] to start.




Fig.3) Actuation Test of left outside mirror.
4. Dose left outside mirror motor work properly?





Check left outside mirror sensor
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Monitor the "MIRROR HORI. POS" Parameter on the Scantool. While operating left outside mirror switch.

Specification : The furthest left -> Approx. 1.0 V,
The furthest right -> Approx. 3.5 V





Fig.4) Current Data of left outside mirror horizontal position.
Fig.5) Output voltage of outside mirror sensor as a function of horizontal position of outside mirror
4. Is the measured voltage within specifications in Fig.5)?